Table of Contents
Advertisement
Table 41 WAN Connection: PPPoA Routed (continued)
LABEL
No
authentication/
PAP/CHAP
User name
Password
Configure
7.4.5 Add a PPPoA Bridged WAN Connection
If you select PPPoA bridged as the WAN service type in the Create Service
screen, the following setup screen is displayed.
Figure 58 WAN Connection: PPPoA Bridged
The following table describes the labels in this screen.
Table 42 WAN Connection: PPPoA Bridged
LABEL
Description
VPI
VCI
Discover IP
Subnet from IPCP
P-794H User's Guide
DESCRIPTION
Select the authentication protocol type provided by your ISP. You can
choose from No authentication, PAP, or CHAP.
The P-794H supports PAP (Password Authentication Protocol) and
CHAP (Challenge Handshake Authentication Protocol). CHAP is more
secure than PAP; however, PAP is readily available on more platforms.
Enter the user name exactly as your ISP assigned. If assigned a name
in the form user@domain where domain identifies a service name,
then enter both components exactly as given.
Enter the password associated with the user name above.
Click this to save your changes.
DESCRIPTION
Enter a short description for this WAN connection.
The valid range for the VPI is 0 to 255. Enter the VPI assigned to you.
The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for
local management of ATM traffic). Enter the VCI assigned to you.
Select enable if you want to get your IP subnet from the PPP Internet
Protocol Control Protocol (IPCP). If not, select disable.
Chapter 7 WAN Setup
97
Advertisement
Table of Contents
