Table of Contents
Advertisement
Chapter 7 WAN Setup
The following table describes the fields that are available only in the Advanced
screen. Refer to
Edit PPPoE screen.
Table 58 PPPoE Routed: Edit PPPoE (Advanced)
LABEL
Hdlc
LLC
Dialout
Username
Dialout Password
Confirmation
Password
Interface ID
Remote Ip
Local Ip
Magic Number
Remote DNS
Remote
Secondary DNS
Tcp Add Port
Num
Tcp Del Port Num Enter the TCP Del Port Number in this field.
Udp Add Port
Num
Udp Del Port
Num
Idle Timeout
Change
Reset
126
Table 57 on page 123
DESCRIPTION
Select true if you want to enable High Level Data Link Control (HDLC)
header so that the P-794H can transmit and receive packets
containing HDLC headers. Select false if you want to disable it.
Select true if you want to enable LLC header so that the P-794H can
transmit and receive packets containing LLC headers. Select false if
you want to disable it.
Enter the dial-out user name in this field.
Enter the dial-out password in this field.
Re-enter the dial-out password for confirmation.
Enter the interface ID for this connection.
Enter the IP address supplied to the remote end of the PPP connection
during negotiation.
If the IP address for PPP connection is not set for the remote peer, it
will use the IP set in this field. But if the remote peer already set its IP
address for PPP connection, you must not set the Remote IP or the
connection will fail.
Enter the local IP address to be associated with the local end of the
WAN interface after a successful connection.
Enter the Magic Number which establishes and identifies the PPP link.
Enter the primary local DNS server address that will be given to a
remote PPP peer when the peer requests a primary DNS server IP
address using IPCP.
Enter the secondary local DNS server address that will be given to a
remote PPP peer when the peer requests a secondary DNS server IP
address using IPCP.
Enter the TCP Add Port Number in this field.
Enter the UDP Add Port Number in this field.
Enter the UDP Del Port Number in this field.
Enter the period of time for idling (no activity) before the system auto-
disconnects the connection. Enter "0" if you do not want the system to
time out.
Click this to save your changes.
Click this to restore your previously saved settings.
for the other fields that are shown in the
P-794H User's Guide
Advertisement
Table of Contents
