Table of Contents
Advertisement
Configuration
(Standalone)
Sound-Active
Mode
Automatic Mode
Master/Slave
Mode
Page 12 of 16
Set the product in one of the standalone modes to control without a DMX controller.
1.
Connect the product to a suitable power outlet.
2.
Turn the product on.
Never connect a product that is operating in any standalone mode (Automatic or
Sound) to a DMX string connected to a DMX controller. Products in standalone
mode may transmit DMX signals that could interfere with the DMX signals from
the controller.
To enable the Sound-Active mode, do the following:
1.
Press <MENU> repeatedly until SNd shows on the display.
2.
Press <ENTER>.
3.
Turn the music on and adjust the microphone sensitivity knob until the product
starts responding to the beat of the music.
The product will only respond to low frequencies of music (bass and drums).
To enable the Automatic Mode, follow the instructions below:
1.
Press <MENU> repeatedly until P-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to choose from the different auto programs (P1-P8).
4.
Press <ENTER>.
The Master/Slave mode allows a single Radius™ 2.0 unit (the "master") to control the
actions of one or more Radius™ 2.0 units (the "slaves") without the need of a DMX
controller. The master unit will be set to operate in either Automatic or Sound-Active
mode, while the slave units will be set to operate in Slave Mode. Once set and
connected, the slave units will operate in unison with the master unit.
Configure the units as indicated below.
Slave units:
1.
Press <MENU> repeatedly until 512 shows on the display.
2.
Press <ENTER> to accept.
3.
Set the DMX address to 001.
4.
Connect the DMX input of the first slave unit to the DMX output of the master unit.
5.
Connect the DMX input of the subsequent slave units to the DMX output of the
previous slave unit.
6.
Finish setting and connecting all the slave units.
Master unit:
1.
Set the master unit to operate in either Automatic or Sound-Active mode.
2.
Make the master unit the first unit in the DMX daisy chain.
·
Configure all the slave units before connecting the master unit to the DMX
daisy chain.
·
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the
master unit.
·
Do not connect more than 31 slave units to the master unit.
·
The Radius™ 2.0 will not work in Master/Slave mode with the Radius™.
Radius™ 2.0 User Manual Rev. 2
Advertisement
Table of Contents
