Speaker Settings - Integra DTR-8.9 Instruction Manual

First Time Setup—Continued

Speaker Settings

4 5
Tape Tuner
If you change these settings, you must run the auto-
7 8
matic speaker setup again (see page 60). Phono Net/USB
+10 0
--/--- 10 11
Input Selector
Macro
1 2
Remote Mode
DVD VCR
TV Cable
SAT
Dimmer
2, 3
+
CH
Enter
Disc
Album
-
1, 6
Prev
CH
Display
Rec Playlist
If the impedance of any speaker is 4 ohms or more but
less than 6, set the Speaker Impedance to 4 ohms.
To use bi-amping or bridging, you must change the
"Speaker Type" setting. For hookup information, see
pages 25–26.
Notes:
• When bridging is used, the AV receiver is able to drive
up to 5.1 speakers in the main room.
• When bi-amping is used, the AV receiver is able to
drive up to 5.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
The onscreen menus shown in this manual may be
slightly different from what you see on your TV.
1 Press the [Receiver] button, fol-
lowed by the [Setup] button.
Receiver
The main menu appears onscreen.
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [ ]/[ ] but-
tons to select "2. Speaker
Setup", and then press [Enter].
The "Speaker Setup" menu appears.
Enter
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
Enter
5. Equalizer Settings
6. THX Audio Setup
-
6
CD
9
TV VOL
D.TUN
Clear
12
3 Zone 3
CD Zone 2
CDR/MD/Dock
1
Receiver
Net/USB
Tape/AMP
Sleep
2–5
VOL
Muting
Random
3
Use the Up and Down [ ]/[ ] but-
tons to select "1. Speaker Set-
tings", and then press [Enter].
The "Speaker Settings" menu appears.
Enter
2–1. Speaker Settings
Speaker impedance
Speaker Type
Front
Enter
MOVE
4
Use the Up and Down [ ]/[ ] but-
tons to select "Speaker imped-
ance", and use the Left and Right
[ ]/[ ] buttons to select:
Enter
4ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
5
Use the Up and Down [ ]/[ ] but-
tons to select "Speaker Type,"
and use the Left and Right
[ ]/[ ] buttons to select:
Enter
Normal:
Select this if you've connected your
front speakers normally.
Bi-Amp:
Select this if you've connected your
front speakers for bi-amped opera-
tion.
BTL:
Select this if you've connected your
front speakers for bridged opera-
tion. The BTL indicator will appear
on the display.
6 Press the [Setup] button.
Setup closes.
Note:
This procedure can also be performed on the AV receiver
by using its [Setup] button, arrow buttons, and [Enter]
button.
6ohms
Normal
VALUE RETURN RETURN SETUP EXIT
57