Speaker Settings - Integra DTR-6.9 Instruction Manual

First Time Setup—Continued

Speaker Settings

If you change these settings, you must run the auto-
matic speaker setup again (see page 48).
If the impedance of any speaker is 4 ohms or more but
less than 6, set the minimum speaker impedance to 4
ohms.
If you've connected your front speakers to the FRONT
L/R and SURR BACK L/R terminal posts for bi-amping,
you must change the "Speakers Type" setting. For
hookup information, see "Bi-amping the Front Speak-
ers" on page 18.
Notes:
• When bi-amping is used, the AV receiver is able to
drive up to 5.1 speakers in the main room.
• Before you change these settings, turn down the vol-
ume.
1 Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2 Use the Up and Down [ ]/[ ] but-
tons to select "2. Speaker
Setup", and then press [Enter].
The "Speaker Setup" menu appears.
3 Use the Up and Down [ ]/[ ] but-
tons to select "1. Speaker Set-
tings", and then press [Enter].
The "Speaker Settings" menu appears.
44
2. Speaker Setup
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
2–1. Speaker Settings
Speakers Type Normal
Speaker Impedance 6ohms
4 Use the Up and Down [ ]/[ ] but-
tons to select "Speakers Type",
and then use the Left and Right
[ ]/[ ] buttons to select:
Normal: Select this if you've con-
Bi-Amp:Select this if you've con-
Notes:
• Powered Zone2 cannot be used if
"Speakers Type" is set to "Bi-Amp".
• The analog multichannel input can-
not be used if "Speakers Type" is set
to "Bi-Amp".
5
Use the Up and Down [ ]/[ ] but-
tons to select "Speaker Imped-
ance", and then use the Left and
Right [ ]/[ ] buttons to select:
4ohms: Select if the impedance of any
6ohms: Select if the impedances of all
6
Press the [Setup] button.
The setup menu closes.
Note:
This procedure can also be performed on the AV receiver
by using its [Setup] button, arrow buttons, and [Enter]
button.
nected your front speakers
normally.
nected your front speakers for
bi-amped operation.
speaker is 4 ohms or more but
less than 6.
speakers are between 6 and
16 ohms.