Analog Audio Input Setup; Speaker Settings - Integra DTR-80.1 Instruction Manual

First Time Setup—Continued

Analog Audio Input Setup

If you connect a component to the AV receiver's analog
multichannel input, you must assign that input to an
input selector. For example, if you connect your DVD/
BD player to the MULTI CH input, you must assign it to
the DVD/BD input selector.
1
Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.
2
Use the Up and Down [ ]/[ ] but-
tons to select "1. Input/Output
Assign", and then press [Enter].
The "Input/Output Assign" menu
appears.
3
Use the Up and Down [ ]/[ ] but-
tons to select "5. Analog Audio
Input", and then press [Enter].
The "Analog Audio Input" menu
appears.
4
Use the Left and Right [ ]/[ ]
buttons to select an input selec-
tor.
You can assign the multichannel input
to the following input selectors:
"DVD/BD", "VCR/DVR", "CBL/
SAT", "Game", "AUX1", "AUX2",
"TV/Tape", "CD", or "Phono". If you
don't want to assign the multichannel
input, set to "- - - - -".
54
1. Input/Output Assign
1. Monitor Out
2. HDMI Input
3. Component Video Input
4. Digital Audio Input
5. Analog Audio Input
6. Gamma Curve
1–5. Analog Audio Input
Multich - - - - -
Subwoofer Input Sensitivity 0dB
5 Press the [Setup] button.
The setup menu closes.
Notes:
• To listen to the component connected to the
multichannel input, press the [Audio] button and
select the "Audio selector" (see page 125).
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.

Speaker Settings

If you change these settings, you must run
®
Audyssey MultEQ XT Room Correction and
Speaker Setup again (see page 58).
If the impedance of any speaker is 4 ohms or more but
less than 6, set the minimum speaker impedance to 4
ohms.
To use bi-amping, bridging or passive subwoofer, you
must change the "Speakers Type(Front)" setting. For
hookup information, see pages 21 to 23.
Notes:
• When bridging is used, the AV receiver is able to drive
up to 7.2 speakers in the main room.
• When bi-amping is used, the AV receiver is able to
drive up to 7.2 speakers in the main room.
• Before you change these settings, turn down the
volume.
1 Press the [Receiver] button, fol-
lowed by the [Setup] button.
The main menu appears onscreen.
If the main menu doesn't appear, make
sure the appropriate external input is
selected on your TV.