Integra DTR-8.9 Instruction Manual page 14

Front & Rear Panels—Continued
GND screw
This screw is for connecting a turntable's ground
wire.
CD IN
This analog audio input is for connecting a CD
player's analog audio output.
TAPE IN/OUT
These analog audio input and output jacks are for
connecting a recorder with an analog audio input
and output, such as a cassette deck, MD recorder,
etc.
AUX 1 IN
A VCR for playback only or other video source can
be connected here. There's S-Video and composite
video input jacks for connecting the video signal.
GAME/TV IN
A game console or TV output can be connected
here. There's S-Video and composite video input
jacks for connecting the video signal.
CBL/SAT IN
A cable or satellite receiver can be connected here.
There's S-Video and composite video input jacks
for connecting the video signal.
cr
VCR/DVR IN/OUT
A video component, such as a VCR or DVR, can be
connected here for recording and playback. There's
S-Video and composite video input and output jacks
for connecting the video signal.
cs
DVD IN
This input is for connecting a DVD player. There's
S-Video and composite video input jacks for con-
necting the video signal.
ct
FRONT L/R, CENTER, SURR L/R, and SURR
BACK L/R speakers
These terminal posts are for connecting the front,
center, surround, and surround back speakers.
The FRONT L/R and SURR BACK L/R terminal
posts can be used with front speakers and surround
back speakers, respectively, or used to bi-amp or
bridge the front speakers. See "Bi-amping Front
Speakers" on page 25 and "Bridging Front Speak-
ers" on page 26.
dk
MULTI CH input: FRONT L/R, CENTER,
SUBWOOFER, SURR L/R, and SURR BACK
L/R
This analog multichannel input is for connecting a
component with a 5.1/7.1-channel analog audio out-
put, such as a DVD player, DVD-Audio or
SACD-capable player, or an MPEG decoder.
14
dl
PRE OUT: FRONT L/R, CENTER,
SUBWOOFER, SURR L/R, and SURR BACK
L/R
This 5.1/7.1 multichannel analog audio output can
be connected to the analog audio input on a multi-
channel power amplifier for when you want to use
the AV receiver solely as a preamplifier. The SUB-
WOOFER jack is for connecting a powered sub-
woofer.
dm
PRE OUT: Zone 2, Zone 3
These analog audio outputs can be connected to the
line inputs on amplifiers in Zone 2 and Zone 3. The
SW jacks can be connected to the inputs on pow-
ered subwoofers in Zone 2 and Zone 3.
dn
Zone 2 L/R speakers
These terminal posts are for connecting speakers in
Zone 2.
do
AC OUTLET (North American model only)
These switched AC outlets can be used to supply
power to other AV components. The type and num-
ber of outlets depends on the country in which you
purchased your AV receiver.
See pages 22–46 for hookup information.