Integra DTR-8.9 Instruction Manual page 111

Advanced Setup—Continued
2 Use the Up and Down [ ]/[ ] but-
tons to select "2. Speaker
Setup", and then press [Enter].
The "Speaker Setup" menu appears.
Enter
2. Speaker Setup
1. Speaker Settings
2. Speaker Config
3. Speaker Distance
4. Level Calibration
Enter
5. Equalizer Settings
6. THX Audio Setup
MOVE
3
Use the Up and Down [ ]/[ ] but-
tons to select "4. Level Calibra-
tion", and then press [Enter].
The "Level Calibration" screen appears
Enter
and the pink noise test tone is output by
the front left speaker.
2–4. Level Calibration
Enter
Left
Center
Right
SurrRight
SurrBack R
SurrBack L
SurrLeft
Subwoofer
MOVE
Note:
Levels cannot be adjusted for speakers
set to "No" or "None" in the Speaker
Configuration (page 106).
4 Use the Up and Down [ ]/[ ] but-
tons to select a speaker, and use
the Left and Right [ ]/[ ] but-
tons to adjust the level.
Enter
Levels can be adjusted from –12 to
+12 dB in 0.5 dB steps (–15 to +12 dB
for the subwoofer).
Notes:
• The "Center" level cannot be set if
the "Center" is set to "None"
(page 106).
• The "SurrRight" and "SurrLeft" lev-
els cannot be set if the "Surround" is
set to "None" (page 106).
• The "SurrBack R" and "SurrBack L"
levels cannot be set if "Speaker
Type" is set to "Bi-Amp" or "BTL"
(page 57), "SurrBack" is set to
"None" (page 106), or "Powered
Zone2" is being used (page 142).
• The "Subwoofer" levels cannot be
set if "Subwoofer" is set to "No"
(page 107).
ENTER ENTER RETURN RETURN SETUP EXIT
-12.0dB
-12.0dB
-12.0dB
-12.0dB
-12.0dB
-12.0dB
-12.0dB
-15.0dB
VALUE RETURN RETURN SETUP EXIT
5 Repeat step 4 until the volume of
the test tone from each speaker
is the same.
If you're using a handheld sound level
meter, adjust the level of each speaker
so that it reads 75 dB SPL at the listen-
ing position, measured with C-weight-
ing and slow reading.
6
Press the [Setup] button.
Setup closes.
Notes:
• Speaker levels can also be adjusted by using the dedi-
cated buttons on the remote controller. Press the
[Test Tone] button to output the test tone. Use the
[CH Sel] button to select each speaker, and use the
[Level–] and [Level+] buttons to adjust the level.
• This procedure can also be performed on the AV
receiver by using its [Setup] button, arrow buttons, and
[Enter] button.
111