Table of Contents
Advertisement
Optimizing the speaker setting for your listening room
■ If an error screen appears
Press D k / n / l / h to select "RETRY" or
"EXIT" and then press D ENTER.
The following display is an example when "E-9:USER
CANCEL" appears in the OSD.
AUTO:ERROR
. E-9:USER CANCEL
Don't operate
any function.
>RETRY
[
[ ]/[ ]:Select
[ENTER]:Enter
Choices: RETRY, EXIT
• Select "RETRY" to retry the "AUTO SETUP"
procedure.
• Select "EXIT" to exit from the "AUTO SETUP"
procedure.
■ If "WARNING" appears
When this unit detects potential problems during the
"AUTO SETUP" procedure, "WARNING" appears in the
"AUTO:RESULT" display. Check the warning messages
to correct your speaker settings.
Note
Warnings differ from errors in that warnings do not cancel the
"AUTO SETUP" procedure.
1
Make sure the pointer is pointing at
"WARNING" and then press D ENTER to
display the detailed information about the
warning.
The number on the right of "WARNING" indicates
the number of warning messages.
AUTO:RESULT
. WARNING(3)
RESULT
SP
DIST: 4.50/5.30m
LVL : -9.0/+6.5dB
>SET
[ ]/[ ]:Up/Down
[ENTER]:Enter
32
En
EXIT
[
:
3/4/0.1
CANCEL
2
Press D l / h repeatedly to toggle between
the warning displays.
WARNING:W-1
<OUT OF PHASE>
Reverse Channel
FL
CENTER
PL
SL
SBL
[
[ ]/[ ]:Select
[ENTER]:Return
y
• For details about each warning message, see the "AUTO
SETUP" section in "Troubleshooting" on page 109.
• When the corresponding warning message is not
applicable to a speaker, "––" is displayed instead.
Press D ENTER to return to the top
3
"AUTO:RESULT" display.
--
PR
SR
SBR
[
Advertisement
Table of Contents
