ZyXEL Communications NBG-417N User Manual page 95

Note: The three categories shown in this screen are independent of each other.
To change your NBG-417N's advanced WAN settings, click Network > WAN > Advanced. The
screen appears as shown.
Figure 63 Network > WAN > Advanced
The following table describes the labels in this screen.
Table 42 Network > WAN > Advanced
LABEL
Multicast Setup
Multicast
Windows Networking (NetBIOS over TCP/IP)
Allow between LAN
and WAN
Allow Trigger Dial
Auto-bridge
Enable Auto-bridge
mode
Apply
Reset
NBG-417N User's Guide
DESCRIPTION
Check this to enable multicasting. This applies to traffic routed from the
WAN to the LAN.
Leaving this blank may cause incoming traffic to be dropped or sent to all
connected network devices.
Select this check box to forward NetBIOS packets from the LAN to the WAN
and from the WAN to the LAN. If your firewall is enabled with the default
policy set to block WAN to LAN traffic, you also need to enable the default
WAN to LAN firewall rule that forwards NetBIOS traffic.
Clear this check box to block all NetBIOS packets going from the LAN to the
WAN and from the WAN to the LAN.
Select this option to allow NetBIOS packets to initiate calls.
Select this option to have the NBG-417N switch to bridge mode
automatically when the NBG-417N gets a WAN IP address in the range of
192.168.x.y (where x and y are from zero to nine) no matter what the LAN
IP address is.
Click Apply to save your changes back to the NBG-417N.
Click Reset to begin configuring this screen afresh.
Chapter 7 WAN
95