ZyAIR G-405 User's Guide
4.3
Resetting the ZyAIR
If you forget your password or cannot access the ZyAIR, you will need to reset ZyAIR to the factory
defaults. This means that you will lose all configurations that you had previously and the speed of the
console port will be reset to the default of 9600bps with 8 data bit, no parity, one stop bit and flow control
set to none. The use name will be reset to "admin" and the password to "1234".
4.3.1 Method of Restoring Factory-Defaults
You can erase the current configuration and restore factory defaults in three ways:
•
Use the RESET button on the ZyAIR to reset to the factory defaults. Use this method for cases
when the password or IP address of the ZyAIR is not known.
•
Use the web configurator to restore defaults.
4.3.2 Procedure to Use the RESET Button
Make sure the PWR LED is not blinking.
Step 1.
Press the RESET button for about 10 seconds, then release it and press the button in once.
Step 2.
If the PWR LED begins to blink, the defaults have been restored and the ZyAIR restarts.
Wait for the ZyAIR to finish restarting before accessing it again.
4.4
Navigating the ZyAIR Web Configurator
The following summarizes how to navigate the web configurator from the Information screen.
4-2
Introducing the Web Configurator