SuperIO Configuration
Configure ITE8716 Super IO Chipset
OnBoard Floppy Controller
Serial Port1 Address
IR Address
IR Mode
Parallel Port Address
Parallel Port Mode
Parallel Port IRQ
↑↓←→:Move Enter:Select
► OnBoard Floppy Controller
This item is used to enable/disable Floppy Controller.
► Serial Port1 Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port 1.
► IR Address
This item is used to assign the I/O address and interrupt request (IRQ) for the IR port.
► IR Mode
This item is used to set the IR mode. The available settings are :
[IrDA] : An IrDA device for maximum 115200 bit/s.
[ASK IR] : A faster IrDA for 1152000 bit/s.
► Parallel Port Address
This item is used to assign the I/O address for the onboard parallel port .
► Parallel Port Mode
This item is used to set parallel port mode.
► Parallel Port IRQ
This item is used to set parallel IRQ.
CMOS Setup Utility - Copyright (C) 1985-2006, American Megatrends, Inc.
SuperIO Configuration
+/-/:Value
F9:Optimized Defaults
[Enabled]
[Enabled]
Allows BIOS to enable
[3F8/IRQ4]
or disable floppy
[2F8/IRQ3]
controller.
[IrDA]
[378]
[Normal]
[IRQ7]
F10:Save
ESC:Exit
31
Help Item
F1:General Help