Usb Configuration - Foxconn M61PMP-K User Manual

[Disabled] : Disable SATA controller 1 and 2, SATA devices are unusable.
[Device 0] : Enable SATA controller 1, SATA port 1 and SATA port 2 are usable.
[Device 0/1] : Enable SATA controller 1 and 2, SATA port1/2/3/4 are usable.
► nVIDIA RAID Setup
This item is used to enbale/disable RAID mode for each ATA channels while entering setup.

USB Configuration

USB Configuration
Module Version - 2.24.5-13.4
USB Devices Enabled :
Legacy USB Support
USB 2.0 Controller Mode
↑↓←→:Move Enter:Select
► Module Version
This item shows the module version of USB.
► USB Devices Enabled
This item is used to enable or disabled the enhanced host controller interface for USB.
► Legacy USB Support
This item is used to enable the support for USB devices on legacy OS. If you have a USB
keyboard or mouse, set to auto or enabled.
► USB 2.0 Controller Mode
This item is used to set the transmission rate mode of USB 2.0. This function only works under
DOS mode. The available settings are: [High Speed] in 480Mbps; [Full Speed] in 12Mbps.
If USB devices are connected to the computer, the following item will appear:
► USB Storage Configuration
After pressing <Enter>, you can set the reset delay for the USB mass storage device. There
are many different emulation types of this USB device, such as floppy, hard disk and CDROM
can be selected.
CMOS Setup Utility - Copyright (C) 1985-2006, American Megatrends, Inc.
None
+/-/:Value F10:Save
F9:Optimized Defaults
USB Configuration
Enable support for
legacy USB.
Auto option disables
legacy support if no
USB devices are
commected.
[Enabled]
[High Speed]
ESC:Exit
30
Help Item
F1:General Help