Superio Configuration - Foxconn Renaissance User Manual

SuperIO Configuration

CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc.
Configure F71883FG Super IO Chipset
IrDA Address
IrDA Mode
IR Duplex Mode
IRTX Pin Select
IRRX Pin Select
IR Tx to Rx Delay Select
IR Rx to Tx Delay Select
↑↓←→:Move Enter:Select
► IrDA Address
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard infra-
red device.
► IrDA Mode
This item is used to select the IR mode. The available settings are:
[IrDA (1.6us)]: An IrDA device for maximum 115200 bit/s.
[IrDA (3/16 bit)]: A faster IrDA for 1152000 bit/s.
► IR Duplex Mode
This item enables you to determine the transfer mode of the onboard infrared chip. Setting
values are: [Full Duplex], [Half Duplex].
► IRTX Pin Select
This item allows BIOS to Select Transmit pin is in normal condition or inverse the IRTX (IR
Mode).
► IRRX Pin Select
This item allows BIOS to Select Receiver pin is in normal condition or inverse the IRRX (IR
Mode).
► IR Tx to Rx Delay Select
This item allows BIOS to Select IR from Tx to Rx 4 charactersTime Delay. (IR Mode)
► IR Rx to Tx Delay Select
This item allows BIOS to Select IR from Rx to Tx 4 charactersTime Delay. (IR Mode)
SuperIO Configuration
[2F8/IRQ3]
[2F8/IRQ3]
[IrDA (1.6us)]
[Half Duplex]
[Normal]
[Normal]
[No Delay]
[No Delay]
+/-/:Value F10:Save ESC:Exit
F9:Optimized Defaults
27
Help Item
Options
F1:General Help