Off Indicator/Zone Sealed; On Indicator/Zone In Alarm; Fault Indicator; Audible Indications - Bosch ICP-CC488 User Manual

ICP-CC488 | User's Guide | 3.
Table 5: MAINS Indicator
Indicator Definition
On AC MAINS power normal.
Flashing AC MAINS supply has failed.
3.6

Off Indicator/Zone Sealed

The indicator displays when the
system is in the disarmed state and
flashes when a zone becomes unsealed
during the disarmed state. The
indicator stops flashing when all zones
are sealed.
3.7

On Indicator/Zone In Alarm

The indicator displays when the
system is armed in AWAY Mode and
flashes when an alarm occurs. The
indicator resets once a valid user code
is entered.
3.8

FAULT Indicator

The FAULT indicator displays that the
system detected a system fault. Refer to
Section 9. Fault Analysis Mode on page 12
for additional information on system
faults.
Every time a new system fault is
detected (such as, FAULT indicator
flashing), the codepad begins to beep
once every minute. Pressing the [#]
button once cancels the once a min
beep and acknowledges the fault (such
as, FAULT indicator on steady).
Table 6: FAULT Indicator
Indicator Definition
On There is a system fault that
needs to be rectified.
Off The system is normal, there are
no faults.
Flashing There is a system fault that
needs to be acknowledged.
3.9

Audible Indications

Table 7 defines the audible indicators given out by
the codepad buzzer.
Bosch Security Systems, Inc. | 12/08 | F01U089456-02
Codepad Indicators
Table 7:
Audible
Indicator
One short beep
Two short beeps
Three short
beeps
One long beep
One beep every
sec
One short beep
every min
3.10
There are several ways to arm the system depending
on whether you are:
•
Leaving the premises and require all active zones
to be in a ready state for an intruder.
•
Remaining in the premises and only require part
of the system to be in a ready state for an
intruder.
If a zone is not sealed at the end of Exit Time, the
zone is automatically isolated and constantly
displayed on the remote codepad. The zone becomes
an active part of the system when the zone is
restored.
For example, if a window is left open after Exit Time
expired, the window is not an active part of the
system until the window is closed. Opening the
window after Exit Time expired causes an alarm
condition.
Table 8 defines the different methods for arming the
system.
Audible Indicators
Definition
A button was pressed on the
codepad, or Exit Time ended
when armed in STAY Mode 1
or STAY Mode 2.
The system accepted your
code.
The requested function was
executed.
Indicates the end of Exit Time
when armed in AWAY Mode, or
the requested operation was
denied or aborted.
Walk Test Mode is currently
active or a warning before
automatic arming takes place.
There is a system fault waiting
to be acknowledged.

Arming the System

EN | 7