Error Codes; Error Codes - imagistics fx2080 User Manual

Error codes

Dialing errors
D.0.3,
D.0.8
D.0.2
D.0.6,
D.0.7
Reception errors
R.1.1
R.1.2
R.1.4
R.2.3
R.3.1
R.3.3
R.3.4
R.4.1
R.4.2
R.4.4
R.5.1,
R.5.2
R.8.1
R.8.10
R.8.11
Transmission errors
T.1.1
T.1.4
T.2.1
T.2.2
T.2.3
14-24 m
aintenance
The remote unit didn't respond, the call couldn't be completed or [Stop]
was pressed while dialing. Re-try the call. If your machine repeats the
message, call the remote fax unit's operator and verify that unit is oper-
ating properly.
The remote unit is busy. Try the call again.
Either the remote unit didn't respond, the call somehow didn't go
through or [Stop] was pressed while dialing. Try the call again.
The calling fax machine didn't respond to your fax machine. This can
happen if someone dials a wrong number or if the remote machine
restricts access through use of a passcode.
The two fax machines were incompatible. Your machine sends and
receives only ITU-T Group 3 fax communication, the industry standard
since the early 1980s.
[Stop] was pressed on the receiving fax machine.
Poor phone line conditions made fax communication impossible. Call
someone at the remote machine's location.
The sending fax machine detected too many errors from the receiving
fax machine.
The sending fax machine is incompatible or had a document feeder prob-
lem during transmission.
Poor phone line conditions may have prevented your fax machine from
properly printing some or all of the pages it received.
The machine received too much data, overloading the memory.
Either the line disconnected before transmission or the transmitting fax
machine needs maintenance.
The machine has reached its memory capacity.
ECM reception failed (perhaps due to line noise).
A compatibility error occurred.
Line noise or other problems prevented line probing.
The fax machine timed out while waiting for the retrain signal.
The remote fax machine didn't respond to your machine. Call someone at
the remote machine's location.
[Stop] was pressed during transmission.
Either the phone line disconnected during transmission or fax communi-
cation became impossible due to bad phone line conditions. Try the call
again.
The two fax machines were incompatible. Your machine sends and
receives only ITU-T Group 3 fax communication, the industry standard
since the early 1980s.
Bad phone line conditions made fax communication impossible. Condi-
tions can change rapidly, so try the call again later.
& t
roUBleShootinG