Clock And Timer - GE JGSP20 Use And Care Manual

OVEN CONTROL, CLOCK AND TIMER
Clock
The clock must be set to the correct time of day for
the automatic oven timing functions to work properly.
The time of day cannot be changed during a Timed
Baking or Self-Cleaning cycle.
Timer
The timer does not control oven
operations. The maximum setting
on the timer is 9 hours and 55
minutes.
To Reset the Timer
If "TIMER" is displayed, press the INCREASE or
DECREASE pad until the desired time is reached.
If "TIMER" is not displayed, press the TIMER
ON/OFF pad first, then follow the instructions above
to set the timer.
End of Cycle Tones
The end of cycle tone is 3 short beeps followed by
1 beep that repeats every 6 seconds until you press
any operation. If you would like to eliminate the
repeating beeps, press and hold the CLEAWOFF pad
for 10 seconds.
Power Outage
After a power outage, when power is restored the
display will flash and time shown will no longer
be correct-for example, after a 5-minute power
interruption the clock will be 5 minutes slow. The
display flashes until the clock is reset. All other
functions that were in operation when the power
went out will have to be programmed again.
12
To Set the Clock
CLOCK
c1
'n
To Set the Timer
1. Press the TIMER
TIMER
ON/OFF pad.
ON/OFF
c1
2. Press the INCREASE or
DECREASE pad to set the
amount of time on the timer.
To Cancel the Timer
Press and hold the TIMER ON/OFF pad until the
word "TIMER" disappears from the display.
To return the end of cycle tone to the repeating beeps,
press and hold the CLEAR/OFF pad for 10 seconds.
Display Messages
If "door" appears in the display, the oven door is
opened and needs to be closed. If "LOCK" appears
in the display, the oven door is in the locked position.
BAKE, BROIL and COOK TIME cannot be set if the
door is in the locked position.
1.
Press the CLOCK pad.
2. Press the INCREASE or DECREASE
day.
The timer will start automatically
within a few seconds of releasing
the pad. The timer, as you are u
setting it, will display seconds until
1 minute is reached. Then it will
display minutes and seconds until
60 minutes is reached.
After 60 minutes, it will display
hours ("HR" now appears in
display) and minutes until the
maximum time of 9 hours and
55 minutes is reached.
—
—