Installing The Ink Roll - Royal 130cx Instruction Manual

__________________________________________________________________
HOW TO CHANGE THE INK ROLL
This register comes equipped with the ink roll installed. The ink roll releases special ink to the printhead which produces printout
on the paper. After a period of time, depending upon the amount of use, the ink in the roll will be used up. When printout
becomes faint, the ink roll needs to be replaced.
CAUTION:
The ink roll is NOT designed to be re-inked. Under no circumstances should this be done or permanent damage to your cash
register printhead will result. Such damage WILL NOT be covered under Royal's warranty.
REPLACE YOUR INK ROLL FOLLOWING THE INSTRUCTIONS BELOW:
1. Turn the control key to the "open" position and
open the printer compartment.
2. The ink roll is found in front of the printhead
mounted in a plastic cartridge. To remove, grasp
the small clip on the left of the ink roll and pull up.
The ink roll will easily pull away from the printhead.
(Figure I)
3. To replace a new ink roll, insert the ink roll
according to markings "L" (Left) and "R" (Right) by
pressing downward to lock it into position, then
close the printer cover. No tools are necessary.
For best performance, store unopened ink roll
package in a cool, dry place until installed.
NOTE: Replace with ROYAL Ink Roll, Order #013109.
To order, call the Royal Supply Center toll free at 1-888-261-4555.
INSTALLING INK ROLL
11