About Your Printer's Default Settings - Epson LX-1170 User Manual

About Your Printer's Default Settings

The default settings control many printer functions. While you
can often set these functions through your software or printer
driver, you may sometimes need to change a default setting from
the printer's control panel using the Default Setting mode.
The following table lists the default settings and the options you
can select in the Default Setting mode. The settings are explained
in detail after the table. For instructions on changing the default
settings, see "Changing default settings" on page 2-9.
Settings
Page length for tractor*
Skip over perforation
Auto tear off
Auto line feed
Print direction
Software
0 slash
High speed draft
I/F mode
Auto I/F wait time
Baud rate
Parity
Data length
* The options available vary depending on the country of purchase.
** These settings take effect only when IBM 2380 Plus (for LX-300+)/IBM 2381
Plus (for LX-1170) emulation is selected.
Options
Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5,
11, 70/6, 12, 14, 17
On, Off
On, Off
On, Off
Bi-D, Uni-D
EPSON ESC/P, IBM 2380 Plus (for
LX-300+)/IBM 2381 Plus (for LX-1170)
0, 0
On, Off
Auto, Parallel, Serial
10 seconds, 30 seconds
19200, 9600, 4800, 2400, 1200, 600, 300
BPS
None, Odd, Even, Ignore
8 bit, 7 bit
Using the Printer
2
2-3