To select a pitch, press the Pitch button until the three Pitch lights
indicate the pitch you want as shown below.
n = On, o = Off
About Your Printer's Default Settings
The default settings control many printer functions. While you
can often set these functions through your software or printer
driver, you may sometimes need to change a default setting from
the printer's control panel using the default-setting mode.
The following table lists the default settings and the options you
can select in the default-setting mode. The settings are explained
in detail after the table. For instructions on changing the default
settings, see "Changing default settings" on page 5-9.
Settings
Page length for front
tractor*
Page length for rear
tractor*
Skip over perforation
Auto tear-off
Auto line feed
Changing Printer Settings From the Printer's Control Panel
Pitch lights
Pitch
10 cpi
o o n
12 cpi
o n o
15 cpi
o n n
17 cpi
n o o
20 cpi
n o n
PS
n n o
(proportional spacing)
Options
Length in inches: 3, 3.5, 4, 5.5, 6, 7,
8, 8.5, 11, 70/6, 12, 14, 17 inches
Length in inches: 3, 3.5, 4, 5.5, 6, 7,
8, 8.5, 11, 70/6, 12, 14, 17 inches
On, Off
On, Off
On, Off
5
5-3