Using The Control Panel; Selecting A Built-In Font - Epson LX-1170 User Manual

Using the Control Panel

You can control simple printer operations—such as line feeding,
form feeding, loading and ejecting paper, and selecting fonts—
with the buttons on the control panel. The control panel lights
show the printer's status. For information on the buttons and the
lights on the control panel, see "Control Panel Buttons and
Lights" on the first page of this manual.

Selecting a built-in font

Follow these steps to select a built-in font using the buttons on the
printer's control panel:
1. Make sure that the printer is not printing. If it is, wait until
printing is complete.
2. Hold down the Pause button for three seconds to enter the
Micro Adjust mode. The Pause light begins to flash. The three
Tear Off (Font) lights show the current font selection.
3. Press the Tear Off (Font) button repeatedly to cycle through
all of the available selections; then stop when you reach the
desired font with a pattern shown on the control panel. Your
selection stays in effect until you change it again.
Note:
Settings you make in your application programs usually
override settings you make from the printer's control panel. For
best results, use your application to select a font and pitch.
Barcode fonts cannot be selected via the control panel.
2-2
Using the Printer