Light Bulb - GE ZET3038 Owner's Manual

BE SURE ELECTRICAL POWER IS OFF AND ALL SURFACES ARE COOL BEFORE CLEANING ANY
PART OF THE OVEN.
How to
To assure no damage is done to the finish
of the product, the safest way to remove the
remove
adhesive left from packaging tape on new
packaging
appliances is an application of a household
tape
liquid dishwashing detergent, mineral oil or
cooking oil.
Oven
NOTE: The glass cover should be removed only when
cold. Wearing latex gloves may offer a better grip.
light bulbs
CAUTION
oven light bulb, disconnect electrical power
to the oven at the main fuse or circuit breaker
panel.
Be sure to let the light cover and bulb cool
completely.
For your safety, do not touch a bulb with bare
hands or a damp cloth. It can also shorten the
bulb life.
To remove:
1 Turn the glass cover counterclockwise
2 Using gloves or a dry cloth, remove the bulb
To replace:
1 Use a new 130-volt Halogen bulb, not to
2 Using gloves or a dry cloth, remove the bulb
3 Push the bulb straight into the receptacle
4 Place the tabs of the glass cover into the
5 Reconnect electrical power to the oven.
: Before replacing your
1/4 turn until the tabs of the glass cover
clear the grooves of the socket.
by pulling it straight out.
exceed 50 watts.
from its packaging. Do not touch the bulb
with bare fingers.
all the way. Then replace the screen.
NOTE: The screen must be replaced or
the life of the bulb will be reduced.
grooves of the socket. Turn the glass cover
clockwise 1/4 turn.
For improved lighting inside the oven,
clean the glass cover frequently using a
wet cloth. This should be done when the
oven is completely cool.
Care and Cleaning of the Oven
Trivection ™
Apply with a soft cloth and allow to soak.
Wipe dry and then apply an appliance polish
to thoroughly clean and protect the surface.
NOTE: The plastic tape must be removed from all
chrome trim. It cannot be removed if it is baked on.
Receptacle
Glass cover
Receptacle
Wall Oven
Socket
Bulb
Screen
Tab
Use gloves
or cloth
37