Management Reports; Position Report; Z Position Report - Olivetti CMS 140 B euro Instructions Manual

Registering a No Sale
This operation prints a no sale receipt. The activity is registered to
the activity counter in the financial report.
Proceed as follows:
1. Press the [#/NS] key.

Management Reports

Transaction data is maintained in the memory of the cash register as
long as the battery back-up system is in effect. This data can be printed
as a report for management review.
The Management Report can be printed from either the X or Z
position on the control switch.
X Position Report
Sliding the control switch to the X position prints the accumulated
transaction information and RETAINS ALL TOTALS IN MEMORY.
Use this report mode to print periodic reading of the transactions
performed (some users call the X report a mid-day report). X reports
include the PLU Report, Clerk Report, and the X Financial Report.

Z Position Report

Sliding the control switch to the Z position prints the same
information as the X report. The only difference between the two types
of report is, however, that after a Z report printout ALL
TRANSACTION TOTALS ARE RESET TO ZERO, except for the
grand total (some users call the Z report an end-of-day report).
NOTE: To prevent the accidental printing of the Z report, assign a Z
mode manager password as explained in the section entitled
Defining the PRG and Z Mode Manager Password. Once the
password is defined, the Z report will not print unless the
password is entered. If an attempt is made to print a Z report
without entering the correct password, the message "SEC
Code" is displayed.
47