How To Connect An Antenna; How To Connect An External Source; Using A Catv Cable; 75 Ohm Catv Cable - NordicTrack commercial 2450 Manual

Before operating the TV, you must connect an antenna or a 75 ohm CATV cable to the 75 ohm terminal,
an AV cable to the audio/video input jack, or an HDMI cable to the HDMI input jack. Note: Use a CATV cable
to connect to an external source such as a cable box, satellite TV box, VCR, or analog cable. No CATV cable,
antenna, or adapter; AV cable; or HDMI cable is included.

HOW TO CONNECT AN ANTENNA

Place an indoor
VHF antenna or an
outdoor combination
VHF/UHF antenna
in the desired
location. Outdoor
antennas are
subject to weather-
ing that can reduce
signal quality.
Inspect your out-
door antenna and
the lead-in wiring
before connecting
the antenna.

75 Ohm CATV Cable

1. Connect the 75 ohm
CATV cable from
the antenna to the
75 ohm terminal on
the treadmill frame
near the power
cord.
300 Ohm Flat Wire
1. Connect the 300
ohm flat wire from
the antenna to a
300 ohm to 75 ohm
adapter.
Outdoor
Indoor
Combination
VHF
VHF/UHF
Antenna
Antenna
75 Ohm CATV Cable
75 Ohm Terminal
Screwdriver
300
Ohm Flat
Wire
300 to 75
Ohm Adapter
2. Push the 300 ohm
to 75 ohm adapter
onto the 75 ohm
terminal on the
treadmill frame near
the power cord.

HOW TO CONNECT AN EXTERNAL SOURCE

USING A CATV CABLE

1. Connect one end of a 75 ohm CATV cable to the
75 ohm output jack on your external source.
2. Plug in the power cord of your external source.
See your external source user’'s manual for proper
grounding instructions.
3. Connect the 75 ohm CATV cable to the 75 ohm ter-
minal on the treadmill frame near the power cord.
See the drawing at the left.
17
300 to 75 Ohm Adapter
75 Ohm
Terminal