Selecting The Ups Voltage Configuration; Connecting The Host Computer - HP R1500 - UPS XR User Manual

Selecting the UPS voltage configuration

Using a small tool, position the DIP switches according to the desired voltage configuration.
NOTE:
R1500 G3 JPN/TWN 100 V*
R1500 G3 NA
R1500 G3 INTL

Connecting the host computer

CAUTION:
more than one will result in unexpected UPS behavior. If an option card is installed, the serial and
USB communications ports are automatically disabled.
Connect the UPS to a host computer using either the USB cable or the DB9 serial cable included with the UPS.
Install HP Power Protector on the host computer. See the HP website
(http://www.hp.com/go/rackandpower) to download the latest version of HP Power Protector.
NOTE:
guide is available for download from the HP website (http://www.hp.com/go/rackandpower).
Connecting the serial communications port
CAUTION:
communications port to the host computer.
An asterisk (*) indicates the default setting.
Output voltage Input voltage range
90–106 V
110 V 99–116 V
110 V 99–116 V
120 V* 108–127 V
220 V 198–233 V
230 V* 207–243 V
240 V 216–254 V
Only one communications port can be connected to the host computer. Connecting
To install and configure the software, see the software user guide. The software user
Use only the computer interface cable supplied with the UPS to connect the
DIP switch 1 DIP switch 2
Down Down
Down Up
Down Up
Up N/A
Down Up
Up N/A
Down Down
Installation 14