Removing And Replacing The Battery Module - HP R1500 - UPS XR User Manual

Battery Maintenance

Removing and Replacing the Battery Module

27 kg
60 lb
To remove the battery module:
1. Remove the front bezel by pulling on both ends.
Figure 4-2: Removing the front bezel
2. Remove the two screws that secure the battery module in place (1) and slide out the
battery module (2).
Figure 4-3: Removing the battery module
3. Set aside the used battery module for proper disposal. Refer to the section, "Disposing of
Used Batteries," in this chapter.
4. To replace the battery module, reverse the preceding steps.
4-4
WARNING: To prevent personal injury, prepare the area and observe all
materials-handling procedures for removing the battery module, which weighs
27 kg (60 lb).
HP Uninterruptible Power System R12000 XR Models User Guide
2
1