Battery Module Connection - HP R/T2200 G4 NA/JP User Manual

3. Installation

3.2 Battery module connection

This operation must be performed when the UPS is switched off and unplugged from the AC source. In addition, do not
disconnect the connector while the unit is operating from the AC source or in reserve mode.
Note: Before starting the UPS, connect the internal battery. A small amount of arcing may occur when connecting the
batteries.This is normal and does not damage the UPS or present any safety concern.
Installing the new battery module
Perform the removal instructions in reverse order.
● To ensure safety and high performance, only use batteries supplied by HP.
● Take care to firmly press together the two parts of the connector during remounting.
Page 14
A
C
B
Connect the battery module.
A
Never pull on the wires.
Slide the left-hand side of the bezel to
B
the right. Ensure that the push button
locks.
Attach the center panel.
C
792519-001 Edition 1