Table of Contents
Advertisement
5 USAGE
SYSTEM TYPE
Single Actuator (Tilt Only, Recline Only or
Elevate Only)
Multiple Actuator (Tilt/Recline or Single
Actuator System with Power Legs)
Using the Single Function Switch
The powered seating switch will alternate functions (increase tilt angle, decrease tilt angle) after it has been released for a
minimum of three seconds.
1.
Make sure the wheelchair is on a level surface and that the wheelchair is turned on.
2.
Press and hold the powered seating switch to activate the actuator until the seating system is in the desired position.
3.
Release the powered seating switch after the desired position is achieved.
Using the MK6i SPJ+ w/ACC Joystick
For this procedure, refer to FIGURE 6 on page 40.
1.
Make sure the wheelchair is on a level surface and that the wheelchair is turned on.
2.
Press the mode button to switch from driving mode to tilt mode.
The LED will light up with a circle around it.
3.
Move the joystick:
Invacare® Formula™ CG Seating
JOYSTICK
MK6i SPJ+ w/PSS
CMPJ+/PSR/PSF/DISPLAY w/
Alternate Control
CMPJ+/PSR/PSF/DISPLAY w/
Alternate Control
32
POWERED SEATING CONTROL
4 POLE MOTOR
SWITCH OPTION
Single Function Switch (Egg,
Wobble, etc.)
4 Way Toggle
Quad Push Button
THROUGH THE
JOYSTICK (TTJ)
Yes w/SPJ+ w/ACC
Yes with SANODE
Replace 4WSB with Multiple
Actuator Interface Box
Part No 1143155
Advertisement
Table of Contents
