Invacare Formula CG Seating User Manual page 104

7 SETUP/MAINTENANCE
4. Slide the BLACK battery terminal cover back on the BLACK battery cable to expose NEGATIVE battery terminal.
WARNING
NEVER allow any of your tools and/or battery cable(s) to contact BOTH battery post(s) at the same time. An electrical
short may occur and serious personal injury or damage may occur.
5. Remove the locknut that secures the bracket of the POSITIVE battery cable to the POSITIVE (+) battery post of the battery.
6. Remove the locknut that secures the NEGATIVE battery cable to the NEGATIVE(-) battery post of the battery.
7. Repeat STEPS 2-6 until the existing battery wiring harnesses have been removed.
8. Position battery connector bracket or wiring harness onto the 22NF battery as shown.
9. Secure the NEGATIVE battery cable to the NEGATIVE (-) battery post with existing mounting screw and locknut.
10. Secure the bracket of the POSITIVE battery cable to the POSITIVE (+) battery post with existing mounting screw and locknut.
11. Position each battery terminal cover over top of each battery terminal.
12. Secure battery terminal covers in place with one tie-wrap.
13. Repeat STEPS 9-13 to install the remaining wiring harness onto the remaining 22NF battery.
14. Install batteries into wheelchair. Refer to Installing/Removing the Batteries - TDX SP and TDX SR with Elevating Seat on page 93.
Invacare® Formula™ CG Seating
104
Part No 1143155