Invacare® FDX® Power Wheelchair Base
5.8.1 Running Lights Through CMPJ+ Joystick
1.
Use the mode switch to select the light mode.
2.
Move the joystick to turn the lights on or move and hold the
joystick for 3 seconds to turn the lights on in strobe mode.
3.
Move the joystick again to turn lights off.
5.8.2 Running Lights Through Single Function Switch
Location of single function switch will depend on wheelchair
configuration.
1.
Press the single function switch to turn the lights on or hold
the single function switch for 3 seconds to turn the lights on in
strobe mode.
2.
Press the single function switch again to turn lights off.
5.9 Disengaging/Engaging Motor Lock Levers
WARNING!
– DO NOT engage or disengage motor locks until the
power is in the OFF position.
Motor lock disengagement/engagement allows free-wheeling
or joystick controlled operation. Free-wheeling allows an
assistant to maneuver the wheelchair without power.
Motor lock levers are located between the rear caster
assembly and drive wheel on both sides of the wheelchair.
50
1.
Perform one of the following as if viewing the motors from
behind the wheelchair (Detail "A"):
•
Engage (DRIVE) - Move the motor lock levers DOWN to
engage the motors and drive the wheelchair.
•
Disengage (PUSH) - Move the motor lock levers UP to
disengage the motors and push the wheelchair.
5.10 Operating the Wheel Locks
WARNING!
– DO NOT use the wheel locks when the wheelchair
power is on and the motor locks are engaged —
otherwise damage to the wheelchair may result.
1163181-F~00