Rear Wheels - Invacare Veranda User Manual

10 Rear Wheels

WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely. Otherwise
injury or damage may occur.
Removing/Installing Rear Wheels
WARNING
Only a qualified technician may change the size of the rear wheel or the seat-to-floor height.
Make sure both rear wheels are the same size and are installed into the same respective mounting hole before using the
wheelchair. Otherwise, injury may occur.
1. Remove the dust cap, hex screw, spacer and locknut that secure the
rear wheel to the wheelchair frame.
2. Repeat STEP 1 for the opposite rear wheel.
3. To reinstall the rear wheel(s) onto the wheelchair, reverse STEPS
1-2.
4. Torque the locknut to 40 ft-lbs.
5. Adjust the wheel locks. Refer to Adjusting the Anti-Tippers. on
page 39.
Part No. 1148116
Rear Wheel
Dust
Cap
Hex Screw
FIGURE 1 Removing/Installing Rear Wheels
35
10 REAR WHEELS
Axle Mounting
Hole
Spacer
Invacare® Veranda™Wheelchair
Locknut
Wheelchair
Frame