Adjusting The Footboard Assembly - Invacare Pronto M41 Owner's Manual

SECTION 9—FOOTBOARD ASSEMBLY
Shroud
Mounting
Hole
Quick Release Pin
FIGURE 9.1 Removing/Installing the Footboard Assembly

Adjusting the Footboard Assembly

Angle
NOTE: For this procedure, refer to FIGURE 9.2.
1. Loosen the jam nut and set screw located underneath on the backside of the footplate.
2. Adjust the set screw in or out to obtain the desired footboard assembly angle.
3. Thread the jam nut and washer inward until it is flush with the footboard bracket.
4. Securely tighten the jam nut and washer to secure the mounting screw in place.
Set Screw, Washer
and Jam Nut
FIGURE 9.2 Adjusting the Footboard Assembly - Angle
Pronto® M41 with SureStep®
Footboard
Assembly
Detent
Ball
42
DETAIL "A" - TOP VIEW
OF FOOTBOARD
Outer Edge of Tube
Detent Balls
Release Pin
Footboard Assembly
Part No. 1143206
Quick