Section 11-Shroud And Wheels; Replacing The Flat Free Tires On The Wheel Rim; Removing/Installing The Top Shroud - Invacare Pronto M41 Owner's Manual

SECTION 11—SHROUD AND WHEELS
SECTION 11—SHROUD AND
WHEELS
After any adjustments, repair or service and before use, make sure that all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service verify that on/off switch
on the joystick is in the off position.

Replacing the Flat Free Tires on the Wheel Rim

DO NOT attempt to replace flat free tires. This procedure MUST be performed by
a qualified technician.
NOTE: During initial use of the wheelchair, the user may experience flat spots on the wheels. Flat
spots will vanish with continued use of the wheelchair.

Removing/Installing the Top Shroud

NOTE: For this procedure, refer to FIGURE 11.1 on page 51.
Removing
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 38.
2. Remove the four mounting screws that secure the top shroud to the wheelchair frame.
Installing
1. Pull joystick cable through the center hole in the top shroud.
2. Position the top shroud onto the wheelchair frame.
3. Using the four mounting screws, secure the top shroud to the wheelchair frame.
4. Install the seat. Refer to Removing/Installing the Seat Assembly on page 38.
Pronto® M41 with SureStep®
WARNING
WARNING
50
Part No. 1143206