Invacare Pronto M41 Owner's Manual page 60

SECTION 13—BATTERIES
5. Disconnect the left battery from the right battery (RED and BLACK connectors).
6. Lift left and right battery out of the battery tray using the battery handles.
Installing
1. Verify the joystick On/Off switch is in the Off position and disconnect joystick cable.
Refer to Disconnecting/Connecting the Joystick on page 57.
2. Position the right battery in the battery tray.
3. Position left battery in the battery tray.
NOTE: Ensure that both batteries are properly seated and resting on the battery tray.
4. Connect the left battery to the right battery (RED and BLACK connectors).
5. Connect the right battery to the controller (BLACK connector).
6. Install the top shroud. Refer to Removing/Installing the Top Shroud on page 50.
7. Install the seat. Refer to Removing/Installing the Seat Assembly on page 38.
8. Connect the joystick cable. Refer to Disconnecting/Connecting the Joystick on page 57.
Wiring Diagram
U1 Batteries
BLACK
Seat
Left
Right
Connector to
Battery
Battery
Controller
Shroud
Plug Into
Controller
Batteries
Battery Tray
BLACK
Connectors
RED Connectors
FIGURE 13.1 Removing/Installing the Batteries
60
Pronto® M41 with SureStep® Part No. 1143206