Removing/Installing Forks And/Or Caster Assemblies; Adjusting Anti-Dive Springs - Invacare Pronto M41 Owner's Manual

SECTION 11—SHROUD AND WHEELS

Removing/Installing Forks and/or Caster Assemblies

NOTE: For this procedure, refer to FIGURE 11.4.
NOTE: Front and rear forks are replaced in the same manner.
Removing
1. Remove the caster from the fork if necessary. Refer to Removing/Installing Casters on
page 52.
2. Remove the head tube cap.
3. Remove locknut, washer and spacer securing the fork to the headtube.
Installing
1. Insert threaded post of fork into headtube.
NOTE: Check the bearing assemblies. Replace if necessary.
2. Slide the fork completely into headtube.
3. Secure fork to headtube with locknut, washer, and spacer. Secure tightly.
Improper positioning of the washer will prohibit the free movement of the forks
which may result in injury to the occupant.
4. Install the caster onto the fork if removed. Refer to Removing/Installing Casters on
page 52.
5. Install headtube cap.

Adjusting Anti-Dive Springs

DO NOT attempt to replace or adjust the anti-dive springs. This procedure MUST
be performed by a qualified technician.
NOTE: The anti‐dive springs may be adjusted accordingly to users weight.
Pronto® M41 with SureStep®
WARNING
WARNING
54
Part No. 1143206