Grandstream Networks GXP1450 User Manual page 47

Confirm Password
Internet Protocol
IPv4 Address Type
DHCP Host name (Option 12)
DHCP Vendor Class ID
(Option 60)
Allow DHCP Option 120 to
override SIP Server
PPPoE Account ID
PPPoE Password
PPPoE Service Name
IPv4 Address
Subnet Mask
Gateway
DNS Server 1
DNS Server 2
Preferred DNS Server
IPv6 Address Type
Static IPv6 Address
IPv6 Prefix Length
IPv6 Prefix
DNS Server 1
DNS Server 2
Preferred DNS server
802.1x mode
FIRMWARE VERSION 1.0.4.23
characters.
Confirms the end user password field to be the same as above.
Selects Prefer IPv4 or Prefer IPv6.
Allows users to configure the appropriate network settings on the phone
to obtain IPv4 address. Users could select "DHCP", "Static IP" or
"PPPoE". By default, it is set to "DHCP".
Specifies the name of the client. This field is optional but may be
required by some Internet Service Providers.
Used by clients and servers to exchange vendor class ID.
Enables DHCP Option 120 from local server to override the SIP Server
on the phone. The default setting is "No".
Enter the PPPoE account ID.
Enter the PPPoE Password.
Enter the PPPoE Service Name.
Enter the IP address when static IP is used.
Enter the Subnet Mask when static IP is used for IPv4.
Enter the Default Gateway when static IP is used for IPv4.
Enter the DNS Server 1 when static IP is used for IPv4.
Enter the DNS Server 2 when static IP is used for IPv4.
Enter the Preferred DNS Server for IPv4.
Allows users to configure the appropriate network settings on the phone
to obtain IPv6 address. Users could select "Auto-configured" or
"Statically configured" for the IPv6 address type.
Enter the static IPv6 address when Full Static is used in "Statically
configured" IPv6 address type.
Enter the IPv6 prefix length when Full Static is used in "Statically
configured" IPv6 address type.
Enter the IPv6 Prefix (64 bits) when Prefix Static is used in "Statically
configured" IPv6 address type.
Enter the DNS Server 1 for IPv6.
Enter the DNS Server 2 for IPv6.
Enter the Preferred DNS Server for IPv6.
Allows the user to enable/disable 802.1x mode on the phone. The
default value is disabled. To enable 802.1x mode, this field should be set
GXP2120/GXP2110/GXP2100/GXP1450 USER MANUAL Page 47 of 69