Grandstream Networks GXP1450 User Manual page 39

SIP Server
Secondary SIP Server
Outbound Proxy
SIP User ID
Authenticate ID
Authenticate Password
Name
DNS Mode
TEL URI
SIP Registration
Unregister On Reboot
FIRMWARE VERSION 1.0.4.23
The URL or IP address, and port of the SIP server. This is provided by
your VoIP service provider (ITSP).
The URL or IP address, and port of the SIP server. This will be used
when the primary SIP server fails.
IP address or Domain name of the Primary Outbound Proxy, Media
Gateway, or Session Border Controller. It's used by the phone for
Firewall or NAT penetration in different network environments. If a
symmetric NAT is detected, STUN will not work and ONLY an Outbound
Proxy can provide a solution.
User account information, provided by your VoIP service provider
(ITSP). It's usually in the form of digits similar to phone number or
actually a phone number.
SIP service subscriber's Authenticate ID used for authentication. It can
be identical to or different from the SIP User ID.
The account password required for the phone to authenticate with the
ITSP (SIP) server before the account can be registered. After it is saved,
this will appear as hidden for security purpose.
The SIP server subscriber's name (optional) that will be used for Caller
ID display.
This parameter controls how the Search Appliance looks up IP
addresses for hostnames. There are four modes: A Record, SRV,
NATPTR/SRV, Use Configured IP. The default setting is "A Record". If
the user wishes to locate the server by DNS SRV, the user may select
"SRV" or "NATPTR/SRV". If "Use Configured IP" is selected, please fill
in the three fields below:
•
Primary IP: The primary IP address where the phone sends DNS
query to;
•
Backup IP 1;
•
Backup IP 2.
If the phone has an assigned PSTN telephone number, this field should
be set to "User=Phone". Then a "User=Phone" parameter will be
attached to the Request-Line and "TO" header in the SIP request to
indicate the E.164 number. If set to "Enable", "Tel:" will be used instead
of "SIP:" in the SIP request. The default setting is "Disable".
Selects whether or not the phone will send SIP Register messages to
the proxy/server. The default setting is "Yes".
If set to "Yes", the SIP user's registration information will be cleared
when the phone reboots. The SIP Contact header will contain "*" to
GXP2120/GXP2110/GXP2100/GXP1450 USER MANUAL Page 39 of 69