Scanning The Channels - Kenwood TK-3230 Instruction Manual

Scanning the channeLS

You can scan the transceiver channels to search for a signal.
When the transceiver verifies a signal on a channel, it proceeds
to check whether or not its QT/ DQT setting matches that
which is set up on your transceiver (if you have set a channel
with QT/ DQT). If the QT/ DQT matches, the transceiver stops
at the channel and opens the squelch so you can listen to the
call. If the QT/ DQT does not match, the call is ignored and
scanning continues.
Before you can use the scan function, ensure that it is
activated. You can turn the scan function (the ability to perform
scan) ON or OFF in Setting mode.
 With the transceiver power OFF, press and hold the MENU
key while turning the transceiver power ON (for 1 second).
 Press the
 Press the MENU key then press
(scan function disabled) or "
• If you select "
scan by pressing and holding the
 Press the MENU key to exit the selection.
 Press the PTT, MON, or CAL key to exit Setting Mode.
or key to select "
", you will no longer be able to perform
".
or to select "
" (scan function enabled).
key {page 18}.
"
7