Storing Data In Simplex Channels; Storing Data In Split Channels - Kenwood TH-G71A Instruction Manual

STORING DATA IN SIMPLEX CHANNELS
Select the desired band.
Select the desired frequency and related data (Tone,
CTCSS, etc.) using VFO mode, Memory Recall
{page 19}, or the Call channel {page 21}.
Press [F].
* Amemory channel number appears and blinks.
e A triangle icon appears below the memory channel
number when the current channel contains data.
1) walle ber
I La
Turn the Tuning control to select the desired memory
channel.
Press [MR].
e The selected frequency and related data are stored in
the memory channel.
« If the memory channel selected in the previous step
already contained data, the new data overwrites the
previous data.
STORING DATA IN SPLIT CHANNELS
1 To store the desired receive frequency and related
data, use steps 1 to 5 given for Simplex Memory
Channels.
Select the desired transmit frequency.
Press [F].
Turn the Tuning control to select the memory channel
that you selected in step 1.
Press [PTT]+[MR].
e The selected transmit frequency is stored in the memory
channel.
Note:
*
{f you selected an offset direction in step 1, you can also press [REV]
in step 2 to select a transmit frequency. The transmit frequency
separated by the current offset frequency will be stored in the
memory channel.
Transmit Offset status and Reverse status are not stored in a split
memory channel,
To store data other than frequencies, select the data in step 1, not
Step 2.