Simplex Channels; Temporary Frequency Changes; Memory Channel Scroll; Memory Transfer - Kenwood TS-870S Instruction Manual
Intelligent digital enhanced communications system
Hide thumbs
Also See for TS-870S:
- Instruction manual (105 pages) ,
- In-depth manual (28 pages) ,
- Operation manual (8 pages)
Table of Contents
Advertisement
9 MEMORY FEATURES
M@ Temporary Frequency Changes
After recalling a memory channel, it is possible to
change the displayed frequency without altering the
frequency that is actually stored in that memory
channel. After changing the frequency, you could
then store the new frequency in a memory channel if
you wanted to save it for future use.
1 Set Menu No. 49 (CH.SHIFT) to ON.
2
Recall a memory channel.
+
You can change operating mode by pressing
[LSB/USB], or [CW/-A], or [FSK/-R], or
[FM/AM]. This is true whether Menu No. 49
{CH.SHIFT) is ON or OFF.
Note:
Memory channels can be tuned in this manner while
using the TF-SET function.
MEMORY CHANNEL SCROLL
Memory Scroll allows you to check memory channeis
without changing your current receive frequency. Only
the display changes; the receiver doesn't alter its
receive frequency. This function could be useful if, while
monitoring a frequency, you wanted to consult the
frequencies stored in your programmed memory
channels.
1
Press [M.IN}.
+
The memory channel that was last selected
appears. This is the same channel that would be
selected if [RX M.CH] were pressed.
acc Ava
fu (2 1S600_
2 Turn the M.CH/VFO.CH control, or press Mic [UP] or
[BWN], to step through the memory channels.
3 To exit Memory Scroll, press [CLR], or [SEND], or
Mic [PTT].
+
The transceiver re-displays the memory channel
or VFO frequency that was selected befare you
activated Memory Scroll. This is true even if you
scrolled through some memory channels.
»
Another way to exit is to close your CW key while
the VOX function is ON.
56
MEMORY TRANSFER
m@ Memory = VFO Transfers
In Memory Recall mode, press [M>VFO}.
Note:
If a memory channel !s recalled, then the recalled data is
changed but nat saved to the memory channel, pressing
{M>VFO] transfers the new data to the VFO.
This table illustrates how memory channel data
transfers to the VFOs and which VFQs are selected for
receive and transmit after the transfer.
Simplex channels:
Channel data
Split-frequency
RX
TX
channels:
data
data
bogs
;
Before
RX | TX || RX | TX
receive VFO that was selected.
Advertisement
Table of Contents
