Table of Contents
Advertisement
Fitting the roof connection and profile rails
5.5
Slate/shingle roofs
i
USER NOTE
A roofer must carry out the installation
on slates or shingles.
Here is an example of the installation of the special roof
hooks and the watertight seal with custom flashing
(Fig. 26, Item 1 and 2) with a shingle/slate roof.
During installation, please maintain the required distanc-
es (w, x and y) between the special roof hooks as de-
tailed in (Tab. 5 and Tab. 6, page 15).
B Fit special roof hook (Fig. 26, Item 5) and gasket
(Fig. 26, Item 4) to the slate/shingle roofs using
screw (Fig. 26, Item 6).
B To ensure that the installation is watertight, flashing
(Fig. 26, Item 1, 2) must be installed on the building
above and below the special roof hooks.
i
User note:
The special roof hooks must be posi-
tioned on the front of a multiple roof
(Fig. 26, Item 3).
5.6
Sheet roofs
i
USER NOTE
A roofer must carry out the installation on
a sheet steel roof.
Carriage bolts (Fig. 27, Item 5) must be used instead of
roof hooks for fastening the profile rails. During installa-
tion, please observe the distances (w, x and y) between
Carriage bolts as detailed in (Tab. 5 and Tab. 6,
page 15).
To ensure the roof is water tight, sleeves for the carriage
bolts (Fig. 27, Item 5) must be soldered onto the sheet
steel roof.
i
USER NOTE
For the fitting sequence for carriage bolts
and profile rails, and the relevant instruc-
tions, see Chapter 5.4 "Corrugated sheet
steel roofs".
24
Fig. 26 Mounting on slate/shingle roof
Item 1: Flashing (on building)
Item 2: Flashing (on building)
Item 3: Multiple tites
Item 4: Gasket (on building)
Item 5: Special roof hooks
Item 6: Screw
5
Fig. 27 Mounting on sheet steel roof
Item 1: Holding bracket
Item 2: M12 nut
Item 3: Washer
Item 4: Sealing disc
Item 5: M12 carriage bolt
Item 6: Sleeve (not supplied)
6
4
5
4
3
63043965.27-1.SD
63043965.27-1.SD
1
2
3
4
1
5
2
3
6
4
63043965.29-1.SD
63043965.29-1.SD
6 720 613 055 (2006/04)
1
2
Advertisement
Table of Contents
