Table of Contents
Advertisement
Fitting the roof connection and profile rails
5.3
Crown tile roofs
i
USER NOTE
Consult a roofer when installing on a roof
with crown tiles.
During installation, please maintain the required distanc-
es (w, x and y) between the roof hooks as detailed in
(Tab. 5 and Tab. 6, page 15).
According to the roof hook positions shown in (Tab. 5
and Tab. 6, page 15), sufficiently strong boards (Fig. 15,
Item 1) must be attached to the joists (cut out counter-
battens) so that the roof hook can be fitted between the
joists.
i
USER NOTE
If the roof has been fitted with boards, the
same roof hook as with pan tile roofs can
be used (page 16).
It may be possible to fit the roof hooks
over battens.
Preparing roof hook
Before installing, the lower part must be moved to the
correct position.
B Loosen the long hexagon nut (Fig. 16, Item 2).
B Insert bolt into upper hole (Fig. 16, Item 3).
B Loosely fasten lower part of roof hook (Fig. 16,
Item 1). Do not tighten the connection yet.
SYSTEM DAMAGE
through breakage of the roof hook if the
bolt is not positioned in the upper hole, re-
CAUTION!
sulting in uneven load distribution.
18
Fig. 15 Fit boards/planks if necessary
3
Fig. 16 Repositioning lower part of roof hook
Item 1: Lower part of roof hook
Item 2: Long hexagon nut
Item 3: Upper hole for fastening the lower part
Item 4: Cut off if necessary
1
1
63043965.18-1.SD
63043965.18-1.SD
1
2
4
63043965.16-1.SD
63043965.16-1.SD
6 720 613 055 (2006/04)
Advertisement
Table of Contents
