GE Profile PT925 Technical Service Manual page 11

Using the Clock, Kitchen Timer, and Control Lock
_________________________________________________________________________________________
_________________________________________________________________________________________
_________________________________________________________________________________________
To Set the Clock
The clock must be set to the correct time of day for the automatic oven
timing functions to work properly. The time of day cannot be changed
during a timed baking or self-cleaning cycle.
1. Touch the CLOCK pad.
2. Touch the number pads.
3. Touch the START pad.
To Set the Kitchen Timer
1. Touch the TIMER pad.
2. Touch the number pads until the amount of time you want shows in
the display. For example, to set 2 hours and 45 minutes, touch 2, 4
and 5 in that order. If you make a mistake, touch the TIMER pad and
begin again.
3. Touch the START pad.
After touching the START pad, SET disappears; this tells you the time is
counting down, although the display does not change until one minute
has passed. Seconds will not be shown in the display until the last minute
is counting down.
4. When the Kitchen Timer reaches :00, the control will beep 3 times
followed by one beep every 6 seconds until the TIMER pad is touched.
The 6-second tone can be canceled by following the steps in the Special
features of your oven control section under Tones at the End of a Timed
Cycle.
To Reset the Kitchen Timer
If the display is still showing the time remaining, you may change it by
touching the TIMER pad, then touch the number pads until the time you
want appears in the display.
If the remaining time is not in the display (clock, delay start or cooking
time are in the display), recall the remaining time by touching the TIMER
pad and then touching the number pads to enter the new time you want.
To Cancel the Kitchen Timer
Touch the TIMER pad twice.
– 11 –
(Continued next page)