Step 10 - Attaching The Switch Housing - Hunter 41457-01 Installation And Operating Manual

STEP 10 - ATTACHING THE SWITCH HOUSING

The switch housing is made up of
two sections: the upper switch hous-
ing, and the lower switch housing.
ATTACHING THE UPPER SWITCH
HOUSING
1. Partially install two #6-32 x 3/8"
housing assembly screws into the
switch housing mounting plate as
shown in Figure 10a.
Switch
Housing
Mounting
Plate
Upper Plug
Connector
Upper
Switch
Housing
Figure 10a - Attaching Upper Switch
Housing to Switch Housing Mounting
Plate
41457-01 7/2000
2. Feed the upper plug connector
through the center opening of the
upper switch housing. See Figure
10a.
3. Align the keyhole slots in the up-
per switch housing with the hous-
ing assembly screws installed in
sub-step 1.
4. Turn the upper switch housing
counterclockwise until the hous-
ing assembly screws are firmly
situated in the narrow end of the
Housing
keyhole slots as shown in Figure
Assembly
Screw
10b. Install the one remaining #6-
32 x 3/8" housing assembly screw
into the third hole in the upper
switch housing. Tighten all three
screws firmly.
CAUTION
Make sure the upper switch
housing is securely attached to
the switch housing mounting
plate. Failure to properly at-
tach and tighten all three hous-
ing assembly screws could re-
sult in the switch housing and
light fixture falling.
Figure 10b - Mounting the Upper
Switch Housing
®
23