Table of Contents
Advertisement
Switch Housing
Screw two light kit screws from the
hardware bag halfway into the motor
housing. It does not matter which two
screw holes you choose.
Thread theplug connector from the fan
through the upper switch housing. Wrap
keyhole slots around the screws and twist
counterclockwise.
12
Insert the third screw, found in the
hardware bag, into place and then
tighten all three screws.
Make sure the upper switch housing is securely
attached to the mounting plate. Failure to properly
secure all 3 assembly screws could result in the switch
housing fixture falling.
Advertisement
Table of Contents
