Screw two housing assembly screws from the
halfway into the motor housing. It does not matter which two screw
holes you choose.
Insert the third screw, found in the
into place and then tighten all three screws.
Partially install two of the switch housing assembly
screws found in the
two screw holes you choose. Connect the plugs from the
upper and lower switch housings. Make sure to line up
the colored markings on the connectors.
Ceiling Bracket
Downrod
Installing the Switch Housing
bag
hardware bag
bag
hardware bag,
Installing the Light Kit
bag
bag. It does not matter which
Hanging Fan
Wiring
2 of 6
Switch Housing
Assembly Screws
Feed the wire plug through the center hole of the upper
switch housing, then wrap keyhole slots around the
screws and twist counterclockwise.
1 of 6
Switch Housing
Assembly Screws
2 of 6
Switch Housing
Assembly Screws
Align the keyhole slots in the light kit housing with the
two screws. Make sure all the wires from the fan and
the light kit are snug inside the center of the light kit, not
pinched in between the upper switch housing and the
light kit or hanging out of the sides.
Canopy
Blades
WARNING
FAN FALL HAZARD
Make sure screws are tight to secure the upper
switch housing to the mounting plate.
Light
1886
8
Glass/Bulbs