Table of Contents
Advertisement
Switch Housing
Screw two housing assembly screws
from the
hardware bag halfway into
the motor housing. It does not matter
which two screw holes you choose.
Note: Remove the three pre-installed
screws from the switch housing and save
the screws. You will need them later.
Note: Fan style may vary.
Feed the wire plug through the center
hole of the upper switch housing, then
wrap keyhole slots around the screws and
twist counterclockwise.
13
M3624-01 • 10/11/16 • © 2016 Hunter Fan Company
www.HunterFan.com
Insert the third screw, found in
the
hardware bag, into place and
then tighten all three screws.
Make sure the upper switch housing is securely
attached to the mounting plate. Failure to properly
secure all 3 assembly screws could result in the switch
housing fixture falling.
1.888.830.1326
Advertisement
Table of Contents
