• Lift 40 pounds. 41847-01 04/21/2003 If you need help installing the fan, your Hunter fan dealer can di- rect you to a licensed installer or electrician. gathering the tools You will need the following tools for installing the fan: •...
If your existing fan site is suitable, go to the in in in in ins s s s s t t t t t a a a a a llin p p p p p l l l l l a a a a a t t t t t e e e e e section and begin installing your new Hunter fan.
Thread the fan supply line through the outlet box so that the fan supply line extends at least 6" beyond the box as shown in Figure 8. Attach the fan supply line to the outlet box with an approved connector, available at any hardware store or electrical supply house.
Insert the downrod through the canopy and canopy trim ring as shown in Figure 12. Feed wires from the fan through the downrod. Screw the downrod into the fan assembly until tight. IMPOR- TANT! Tighten downrod set screw as shown in Figure 12.
#8-32 x 1” screws. hanging the fan Raise the fan and place the hook through the loop on the ceil- ing plate as shown in Figure 16. Use the note and arrow en- graved in the ceiling plate to assist in determining the direc- tion to assemble.
Remove the blade mounting screws and rubber shipping bumpers from the motor. For each blade, insert one blade mounting screw through the blade iron as shown in Figure 25, and attach lightly to the fan. Insert the second blade mounting screw, then securely tighten both mounting screws.
Page 9
Attach the extra pull chain (included in the sack parts) to the fan pull chain using the plastic breakaway connector. Thread the fan pull chain through the hole in the metal disk. Then, thread the fan pull chain through the small hole beside the hole in the center of the glass bowl.
10 10 10 10 10 installing without the light fixture Your Hunter fan comes with an integrated light fixture assembly and an optional switch housing cap and plug button. This feature gives you the option of installing the fan with or without the in- cluded light fixture.