Gps - Speco DVRM42 User Manual

◀,▶
Press the button to see the next page.
To exit this screen, press the "ESC" button.
NOTE
- You can set the RELAY OUTPUT of each channel for the event type.
- Relay output is from 1 to 4 seconds. You can set the period of the relay output.
<RELAY 4 SELECT>
There are POWER, USER, NOT USED and HDD ERROR.

POWER: The relay is working when power is off.

USER: User can operate the relay manually.
Press the "FUNCTION" button to operate RELAY 4 manually.
NC→NO: And then press the (+) button.
NO→NC: And then press the (-) button.
Press the "FUNCTION" button again if you want to exit this mode.
(You can also use this function through network viewer.)
4.4.7

GPS

At the EVENT menu, move the cursor to the "GPS" using the
Press the ENTER button when the cursor is on the "GPS" and the following screen appears.
User can change the SHOCKSENSOR "ON" by pressing the
X-THRESHOLD:
X-Threshold values are automatically varied when there is any event. The default value is 1.
Y-THRESHOLD:
Y-Threshold values are automatically varied whenever any event occurs. The default value is 0.
Z-THRESHOLD:
Z-Threshold values also change when any event occurs. The default value is 4.
SPEED PARAMETER:
The below said parameter values may change depending on the acceleration speed of the vehicle
a) SPEED LIMIT
b) LENGTHY STOP
c) EXCESSIVE BREAK
d) EXCESSIVE SPEED
▲,▼
buttons.
button from the remote.
25