Ipv6 6To4 Tunnel - NETGEAR N600 DGND3800B User Manual

N600 Wireless Dual Band Gigabit VDSL2 Modem Router DGND3800B

IPv6 6to4 Tunnel

The remote relay router is the router to which your modem router creates the 6to4 tunnel.
Make sure that the IPv4 Internet connection is working before you apply the 6to4 tunnel
settings for the IPv6 connection.
To set up an IPv6 Internet connection by using a 6to4 tunnel:

1. Select ADVANCED > Advanced Setup > IPv6.
The IPv6 screen displays.
2. In the Internet Connection Type list, select 6to4 Tunnel.
The screen adjusts:
The modem router automatically detects the information in the following fields:
• Router's IPv6 Address on WAN. This field shows the IPv6 address that is acquired
for the modem router's WAN (or Internet) interface. The number after the slash (/) is
the length of the prefix, which is also indicated by the underline (_) under the IPv6
address. If no address is acquired, the field displays Not Available.
• Router's IPv6 Address on LAN. This field shows the IPv6 address that is acquired
for the modem router's LAN interface. The number after the slash (/) is the length of
the prefix, which is also indicated by the underline (_) under the IPv6 address. If no
address is acquired, the field displays Not Available.
3. Configure the remote 6to4 relay modem router settings by selecting one of the following
buttons:
• Auto. Your modem router uses any remote relay router that is available on the
Internet. This is the default setting.
• Static IP Address. Enter the static IPv4 address of the remote relay router. This
address is usually provided by your IPv6 ISP.
4. Specify how the modem router assigns IPv6 addresses to the devices on your home
network (the LAN) by selecting one of the following radio buttons:
• Use DHCP Server. This method passes more information to LAN devices, but some
IPv6 systems might not support the DHCv6 client function.
Advanced Settings
114